iBOLT 25mm / 1 inch Ball to Strong VHB Adhesive Mount Base/Adapter - for All Industry Standard 1 inch / 25 mm mounts
iBOLT 25mm / 1 inch Ball to Strong VHB Adhesive Mount Base/Adapter - for All Industry Standard 1 inch / 25 mm mounts
- Make sure this fits by entering your model number.
- This iBOLT 25mm / 1 inch ball dual VHB Adhesive base is made out of heavy duty composite material and is compatible with all industry standard 1 inch / 25 mm mounting arms. Ball joints are coated in a rubber material. *This product is only the iBOLT 25mm VHB Adhesive base. Other images shown are to show the use of the product.
- This heavy-duty mount is ideal for flat surfaces. The adhesive is a very strong VHB and is a permanent mounting solution. To apply the adhesive disk, simply remove the red plastic from the back of the 3M VHB mounting disk, then place and press down on a previously cleaned surface. (Allow 24 hours for the adhesive to cure before securing the base of the mounting pedestal to the center of the disk for best results.)
- With the dual ball adjustments, this mount allows you to have the flexibility of rotating your device 360 degrees.
- The Ball size is 1 inch (25mm) and is to be used with other industry standard 1 inch (25mm) ball mounts
Brand : iBOLT
Category : Electronics,GPS, Finders & Accessories,GPS System Accessories,Vehicle Mounts
Rating : 4
Price : US $8.95
Review Count : 96
iBOLT 25mm / 1 inch Ball to Strong VHB Adhesive Mount Base/Adapter - for All Industry Standard 1 inch / 25 mm mounts
- Compatible with Ram Mount accessories, I stuck this base to the center gauge bezel, just above the emergency hazard light button. Then, I added the Ram \'X\' phone holder & 4\" extension from my motorcycle. Now, I can orient my phone vertically or horizontally, depending on how I\'m using it.
- This is a sturdy mount with a strong adhesive but don\'t think that it will conform to any surface other than one that is perfectly flat. The cuts in the base would suggest so but it\'s not the case. It will not bend to conform with a curved surface. The plastic material is really rigid and if you try to flex it it won\'t budge. If you put too much force it will only snap.So, the design has some good intentions but the material used is inadequate.
- Strong adhesive, base doesn\'t have a lot of flex to it, only works for surfaces that are flat or very gently curved
- Tried to use this for a phone mount inside of a truck. It worked great for about a week and then the adhesive failed on a rough road.
- I used this to mount a RAMX phone holder in my 2020 Kia without having to drill any holes.
- It was easy to install after cleaning the area in my truck. I left it for 2 or 3 days without weight on it. Went to add the arm and the mount just fell off. The double sided tape is garbage and was really easy to peel off the mount itself. Will be using the mount, but will be using 3m automotive double sided tape, that I know will stick.
- Stays where you put it.
- This mount failed and came off within 6 months. Total waste of money. Never had that happen with the RAM brand.
Post a Comment for "iBOLT 25mm / 1 inch Ball to Strong VHB Adhesive Mount Base/Adapter - for All Industry Standard 1 inch / 25 mm mounts"